Logging to file "DUS-IIId.log"

Configuring the simulation environment.


-----------------------------
Diagnostic Utility System III
-----------------------------

Loading DUS-III.

Cold load complete, P: 001231 (LOAD P+14)

Configuring the diagnostic.

Starting the diagnostic.



Diagnostic/Utility System III Revision 01.01
Enter Your Program Name (type HELP for program information)
:IOMAP
               IOMAP            Revision 00.11
 
 
          Enter 'GO' to continue
                'GO ,1' to continue with Line Printer
 
                'GO 1' for Optional Test Sections
                'GO 1,1 ' to run Optional Test Sections with Line Printer
 
                ('LC' to List Commands)
 
>GO
























 IOMAP            SYSTEM I/O CONFIGURATION
-----------------------------------------------------------------
>Control panel switch settings: Channel=0 Device=2
>System console is device 7 on channel 0
-----------------------------------------------------------------
Channel 11  ID=!0      General I/O Channel  (GIC)
  Device 0 ID=!176    7976 Mag Tape Unit
  Device 2 ID=!2      7906/7920/7925 Disc Controller      (CODE=2)
    Unit 0            7920 Disc Drive
    Unit 1            7920 Disc Drive
    Unit 2            7920 Disc Drive
    Unit 3            7920 Disc Drive
    Unit 4            7920 Disc Drive
    Unit 5            7920 Disc Drive
    Unit 6            7920 Disc Drive
    Unit 7            7920 Disc Drive
-----------------------------------------------------------------
Explanation of '(CODE=   )'
     1 implies:  NO LOOPBACK Capability.
     2 implies:  NO SELFTEST Capability. 
------------------------------------------------------------------

End of pass 1
 


Diagnostic/Utility System III Revision 01.01
Enter Your Program Name (type HELP for program information)
:
Simulation stopped, P: 035622 (BL P-1)
sim> q
Goodbye
Debug output disabled
Log file closed