Logging to file "GIC.log"
Debug output to "GIC-debug.log"

Configuring the simulation environment.


------------------------------
General I/O Channel Diagnostic
------------------------------

Loading the GIC diagnostic.

Cold load complete, P: 001231 (LOAD P+14)

Configuring the diagnostic.

Starting the diagnostic.

GIC Diagnostic            Revision 1.26    
Type GO to continue (LC for List Commands)
>GO
Set 'MODE' switch on GIC under test to 'TEST' (out)
Set 'PROCESSOR' switch on GIC under test to 'CPU' ( in)
Set 'DEVICE TYPE' switch on GIC under test to 'A' ( in)
Set 'SYS CTRL' switch on GIC under test to 'ON'  ( in)
Remove cables attached to GIC under test.
More than one Memory Controller installed in system?(Y/N)N
What is the CHANNEL address of GIC under test? 11
Error in step 07 
WIOC CH 11 gave 0000 0111 not setting intp for Dev 7
>
Simulation stopped, P: 075766 (TIO 0)
sim> q
Goodbye
Debug output disabled
Log file closed